J5create JUH450 Manuel De L'utilisateur page 32

USB 3.0 MULTI-ADAPTER
USER MANUAL
intended uses described by j5create ; (g) damage caused by service (including upgrades and expansions) performed by
anyone who is not a representative of j5create or a j5create Authorized Service Provider; (h) a product or part that has been
modified to alter functionality or capability without the written permission of j5create; or (i) if any j5create serial number on the
product has been removed or defaced.
If such a situation occurs, j5create will calculate the cost of materials and repair for your reference.
This warranty is given by j5create in lieu of any other warranties express or implied.
REGULATORY COMPLIANCE
FCC
This equipment has been tested and found to comply with FCC Part 15 Subpart B § 15.109/15.107 Class B.
Operation is subject to the following two conditions:
• This device may not cause harmful interference
• This device must accept any interference, including interference that may cause undesired operation of the
device.
CE
This equipment is in compliance with the requirements of the following regulations:
EN 55022 Class B (2006),
EN 55024 (1998+A1:2001+ A2:2003), (IEC/EN 61000-4-2 (1995+A1:1998+A2:2001)/-3(2006)
C-Tick
This equipment is in compliance with the requirements of the following regulations:
EN 55022 (2006) Class B, AS/NZS CISPR22 © IEC: 2005.
VCCI
This equipment is in compliance with the requirements of the following regulations:
CISPR22 © IEC: 2005
Disclaimer
Information in this document is subject to change without notice. The manufacturer does not make any
representations or warranties (implied or otherwise) regarding the accuracy and completeness of this document
and shall in no event be liable for any loss of profit or any commercial damage, including but not limited to
special, incidental, consequential, or other damage. No part of this document may be reproduced or transmitted
in any form by any means, electronic or mechanical, including photocopying, recording or information recording
and retrieval systems without the expressed written permission of the manufacturer
31