Beta 3965C Mode D'emploi page 4

INSTRUCTIONS FOR USE ISTRUZIONI PER L'USO
WHEEL TRUING STAND
PARTS
1
DESCRIPTION
2
ASSEMBLY
NOTE
The wheel truing stand was calibrated before shipment. However, it is recommended to calibrate timely with truing
stand correction gauge (optional part) to ensure measuring callipers are centred between the uprights, which should
be parallel.
4
N.
Assemble base plates (6) to body (5) by using hexagon key
wrench (6-3) to tighten button head socket bolt (6-1) and hexagon
nut (6-2). (See picture 1)
Install measuring calliper knob (short) (2), measuring calliper arm
knob (long) (4) and through axle hub adaptors (7).
(See picture 2)
PARTS
Measuring callipers
Measuring calliper knob (short)
Measuring upright knob
Measuring calliper arm knob (long)
Body
Base
Button head socket bolt, 5 mm
Hexagon nut, 12 mm
Hexagon key wrench, 5 mm
Through axle hub adaptor
Through axle holder
Spacer
Star knob
Uprights
EN I