VT FOUNTAIN JET SET Mode D'emploi page 10

GB
INSTRUCTIONS FOUNTAIN JET SET
GENERAL
The Fountain Jet Set supplies a perfect jet of water: it does not only have a decorative
effect, but it is also nice for fish. The steady water circulation keeps the pond water
moving and oxygen-rich. At night the watertight led lighting provides a spectacular
effect. The Fountain Jet Set is an illuminated jet of water including pump, hose and
led-lighting with light sensor. The pump should be used in the water.
USE AND SAFETY
Before connecting the pond pump and putting it to use, carefully read the
present instructions for use and safety regulations. The installation and use of
the pumps described here is only allowed for persons from 16 years old, of whom it
can be expected that for these persons the text is clear and understandable.
!
The pump is provided with 10 m of grounded electrical safety cable with flex and
plug. Connection to a grounded receptacle with earth leakage circuit breaker of 30
mA is necessary.
!
Only use good quality grounded extension leads, flexes, receptacles and the like.
!
The flex is watertight. It has an anchored pump housing and may not be replaced
when damaged. If any damage should occur to the flex, the pump may no longer be
used.
!
When carrying out activities in or near the water, all devices that are immersed or
in touch with the pond should be de-energized.
!
Do not displace the pump by lifting it with the help of the flex.
!
The pump is exclusively made to displace water (maximum 35 °C). This means
that transport of any different liquids explicitly excluded.
!
The use of these pumps in swimming pools is not allowed.
!
The pump housing should be installed at least 10 cm and at most 1 m below
water level.
!
The pump should always be placed as level as possible and not in the bottom
sludge. If necessary, you should use an elevation, made from a number of stones.
!
The pump should be used exclusively in the water (wet installation).
!
When the pump is completely installed, it can be connected to the power supply.
INSTRUCTIONS FOR USE
The Fountain Jet Set is supplied completely in a box and is ready for use. Connect
the nozzle (B) to the pump (A) with the enclosed hose. Place the nozzle and light
sensor (C) by means of the ground peg. The light sensor will activate the led-lighting
automatically during darkness. At daylight the lighting is inactive. The pump will
remain functioning. Place the pump ca. 50 cm below water level. If necessary, use
an elevation of stones or a stand. When the pump has been mounted completely,
you can put in the plug.