Usb Driver Software Installation; Switch On - Miditech Midicontrol 2 Mode D'emploi

USB DRIVER SOFTWARE INSTALLATION

When you use this master keyboard with your computer, you must install the USB driver
software on your computer with attached CD-ROM. Put the CD-ROM in your CD-ROM
drive, double click on the "SETUP" icon and the installation will start. You simply follow
instruction to complete all steps. The computer tells you that the software has no digital
signature, but this is no problem, because we don't need a signature, so you can continue.
Many companies in the music business do not signet their driver or software because this is
expensive and need much time for every little change in the software/driver. After the driver
installation (copy of files!) is finished you restart the computer and the computer will start
with the real installation of the driver to his own directory, so you need to follow the
installation. Then you can start your music-software, set up the input-port to the keyboard in
the device-manager or hardware-manager of your music-software, the output to your
soundcard and everything should work. That's all!

SWITCH ON

There are two ways to power the unit:
1. Use USB cable to connect USB socket of computer.
2. Use external adapter: Plug output jack of proper AC adapter into the DC socket in the
rear panel.
3. Slide the power switch to "ON" position. The Display will show "001" as program
number and the unit transmit initial program number to the equipment connected to
MIDICONTROL 2 immediately. When you play on the keyboard, notes and its velocity
message will be transmitted. Note number corresponding to the most left key is 36.
Note:
The default display is program number. After any operation in the unit, the display will return
to program number. After legal operation, the data change will be transmitted immediately.
9