ChickenGuard Extreme Instructions page 6

CHECKING THE BATTERY STATUS AND FIRMWARE
1. Press MENU to enter the programme menu.
2. Press UP or DOWN until you find: MISC SETTINGS
3. Press MENU to enter the miscellaneous mode.
4. Press the UP or DOWN button until you find the firmware/Battery
condition display.
5. The battery status should read OK and tell you the voltage.
6. If the batteries need changing, the LED will remain permanently
lit and a warning will be displayed on the screen.
7. Should the LED be lit but nothing is visible on the LCD screen
then change the batteries immediately.
USING THE LIGHT SENSOR
1. Press MENU to enter the programme menu.
2. Press UP or DOWN until you find: LUX ADJUSTMENT.
3. Press MENU to enter the LUX adjustment mode.
4. Press UP or DOWN and navigate the ">" symbol to the READ
option
5. Press MENU.
6. This will take a quick snapshot of the current light level.
LIGHT SENSOR:
ADJUSTING OPEN/CLOSE SENSOR VALUES
To adjust the OPEN or CLOSE trigger values, navigate the ">"
symbol to either OPEN or CLOSE. Press UP or DOWN button to
select and MENU to save.
Open: Min = 200 Max = 255 DEFAULT = 200
Close: Min = 0 Max = 199 DEFAULT = 80
NB: Darker is a lower number – Brighter is a higher number.
6 chickenguard.com