Metabo HPT DB 3DL2 Instructions De Sécurité Et Mode D'emploi page 14

English
9. Using the light
The light lights when the light switch is pushed.
When the light switch is pushed again, the light
is turned off . (Fig. 12)
CAUTION
Do not look directly into the light. Such
actions could result in eye injury.
10. Using in the straight or pistol grip
Select the grip type that best matches the tool
application. When changing the grip type, the
tool will make a clicking sound when it snaps
into position. Bend (or extend) the tool until the
clicking sound is heard.
THE SCOPE AND SUGGESTIONS
FOR USES
Work
Steel
Drilling
Aluminum
Small screw
Screw tightening
Wood screw
CAUTION
● While operating the cordless driver drill,
take care not to lock the motor.
If the motor is locked, immediately turn the
power off .
If the motor is locked for a while, the motor
or battery will be burnt.
14
Light switch
Fig. 12
Cap position
1 – 21
1 –
CAUTION
● Do not place your fi ngers or any portion
of your body in or near the bending
portion of the tool while operating the
tool or while bending and straightening
the tool because you may be pinched in
the bending portion resulting in possible
injury.
● Do not remove the rubber cover around the
bending portion.
● If the rubber
damaged or lost, contact your metabo HPT
AUTHORIZED SERVICE CENTER. (Fig. 13)
Table 6
Use for drilling purpose.
Use the bit and socket matching the screw
diameter.
Use after drilling a pilot hole.
● Do not tighten too strongly as the screw
heads will be damaged.
cover becomes
Bending portion
Fig. 13
Suggestions
loose,