Functional Description - Haussmann Xpert PNT180 Manuel De L'utilisateur

A
B
D
!
Quick
Connector
Tool
Quick Coupler

FUNCTIONAL DESCRIPTION

Figure 1 names the major components of the HAUSSMANN XPERT
air-powered multi-purpose tool:
A. Airflow control knob
B. Die-cast aluminum housing
E
C. Trigger lever
C
D. Spindle & Blade arbor
E. Air inlet
F
F. Safety catch
Fig.1
SETUP & OPERATION
BEFORE YOU START
Compatible Compressor & Air Tool - Guidelines for Proper Usage & Operation.
Always ensure the use of appropriately matched air tools and compressors. Be sure
that the air compressor being used can supply the appropriate volume, pressure and
delivery rate of air to the tool(s) without running continuously. Using tools or
combinations of tools that together or separately require more than the air compressor
can deliver will reduce performance and could void the compressor or tool warranty.
Note: This air tool may be shipped with a protective plug covering the air inlet.
Remove this plug before set up.
AIR SYSTEM (Fig.2)
Quick
Connector
Air Hose
1. Always use clean, dry and regulated, compressed air at a working pressure of
between 75 and 90 PSI.
2. Never exceed the maximum pressure of 90 PSI. Operating the tool with
excessive pressure could cause personal injury, and may result in excessive
noise and damage to the tool.
3. Keep hands and other parts of the body away from the tool's discharge and
working areas when connecting the air supply.
4. It is recommended that a filter-regulator-lubricator be used, and that it be located
as close to the tool as possible.
5. If a filter-regulator-lubricator is not installed, place up to 6 drops of compressor
oil into the NPT inlet plug before each use.
6. If a filter-regulator-lubricator is installed, keep the air filter clean. A dirty filter will
reduce the air pressure to the tool, which will cause a reduction in power,
efficiency, and general performance.
Filter
Lubricator
Quick
Coupler
Regulator
Air
Compressor
Cut-off
valve
Fig.2
19