Buffalo DB191 Mode D'emploi page 4

UK
Installation
• Remove the pasta cooker from the packaging, ensuring that all protective packaging, plastic and
residues are thoroughly cleaned from its surfaces.
• Appliances should always be placed on the table when in use.
• Before locating and operating the pasta cooker, it is the user's responsibility to ensure that all Health
& Safety regulations concerning safe positioning, spacing, ventilation, electrical installation, and fire
risk, are complied with.
Fitting head unit to the body
• Place the head unit into the right and left support bracket at the rear of the pasta cooker body, then
press the spring pin at the right to position the head unit into the pan.
Water pan
Pasta cooker
body
Drain tap
• The pasta cooker can now be filled with water.
• Connect the pasta cooker to the correct power supply and it is ready to operate.
Caution: Do not position and operate the pasta cooker near combustible or flammable materials or
objects.
Operation
1. Turn the thermostat dial towards the "ON" position. The green light will activate to confirm. Adjust
the dial to the required temperature setting.
2. While heating up, the indicator light will come on; when the required temperature is reached, the
indicator light will go out.
3. As the water temperature fluctuates, the thermostat will operate to maintain the set temperature.
The indicator light will be lit when the pasta cooker is heating the water.
4
DB191_ML_A5_v3_20201124.indb 4 DB191_ML_A5_v3_20201124.indb 4
Head unit
Lid
Support bracket
Basket
Rubber feet
2020/11/24 10:20 2020/11/24 10:20