SEVERIN KM 3908 Mode D'emploi page 12

be checked thoroughly for any defects.
Should the appliance, for instance, have
been dropped onto a hard surface, or if
excessive force has been used to pull the
power cord, it must no longer be used:
even invisible damage may have adverse
effects on the operational safety of the
appliance.
∙ The appliance should only be placed on a
level surface. Do not allow the housing or
its power cord to come into contact with
open fl ames or any hot surfaces such as
hot-plates.
∙ Do not let the power cord hang free.
∙ Do not touch any moving parts during
operation, and do not insert any
implements (e.g. dough spatulas or
cooking spoons) into the bowl unless the
motor has come to a complete standstill.
∙ Always use the appropriate pestle
to feed food into the bowl. Under no
circumstances use your hands.
∙ No responsibility will be accepted if
damage results from improper use, or if
these instructions are not complied with.
Before fi rst use
Remove any packing materials completely
and clean all accessories as described in the
section Cleaning and care.
Operating switch
The operating switch allows for the following
switch settings:
II The unit is switched on – high speed
I The unit is switched on – low speed
0 The unit is switched off
P With the switch held in this position:
On – high speed
12
Wind-up power cord storage
The power cord can be wound up for storage
on the underside of the unit. Unwind it
completely before operation.
Operation:
General information
∙ First, fi t the required attachment.
∙ Note: this kitchen appliance is equipped
with two safety switches and can only be
activated if the selected attachment has
been correctly fi tted and safely locked.
∙ Turn off the appliance after use (switch
position '0') and wait until the motor has
come to a complete standstill before
changing or removing any attachments.
Chopping/mincing and puréeing
∙ Fit the drive shaft to the drive unit.
∙ Attach the bowl with the handle to the
right and turn it clockwise to lock until
the lock symbol and triangular mark are
aligned.
∙ Fit the drive shaft extension to the drive
shaft.
∙ Remove the protective cover and fi t the
chopping/mincing blade to the drive shaft
extension in such a way that the blade
almost touches the bottom of the bowl.
∙ Caution: Hold the blade only by its plastic
shaft - the blades are extremely sharp.
∙ Put the ingredients (max. 700 g) into the
bowl.
∙ Put the lid on the bowl and turn it
clockwise until it locks into place.
∙ For safety reasons, use the appropriate
pestle at all times when feeding the
ingredients down the food chute. During
operation, the pestle should remain
inserted.