Kinderkraft SPARK KKFSPAR Guide D'utilisation page 21

EN
4.4 Booster shoulder guide belt (I)
As the picture show, tie the adaptor belt to the base, then follow the arrow to adjust the belt
to the best length.
Notice：When using as a booster, the shoulder guide belt's position will depend on the
vehicle belt's position, which showed on the above two pictures.
Through the vehicle shoulder belt into the guide belt red hook, then adjust the belts to the
best position. Last, fasten the vehicle belts. Making sure the diagonal belt and the lap belt
must be under the armrest.
5. Removing the cover (H)
Headrest: pull the cover over the top of the headrest. Make sure that the foam parts remain
in position. Backrest: loosen the Velcro fastener at the backside of the cover and pull it over
both lumbar supports. Seat booster: pull the cover over the armrests towards you.
The cover can be refitted using the above instructions in the reverse order. Make sure that
the belt hooks on the headrest (D2) are not obstructed to allow the shoulder belt to pass
through freely.
6. Maintenance and Cleaning
This product requires regular maintenance by the user. Clean the plastic parts with a damp
cloth and a mild detergent and dry thoroughly. Don't use abrasives. The cover may be
washed by hand or by machine with a gentle washing program, with a maximum
temperature of 40 °C. Do NOT tumble dry and NEVER use a dryer.
21