Assembly - Generac Portable Products 7000EXL Manuel D'utilisation

ASSEMBLY

IMPORTANT: Read entire operator's manual before you
attempt to assemble or operate your new generator.
Your generator requires some assembly and is ready for
use after it has been properly serviced with the
recommended oil and fuel.
If you have any problems with the assembly of your
generator, please call the generator helpline at
1–800–270–1408. If calling for assistance, please have the
model, revision, and serial number from the serial number
label available. See "Know Your Generator" for location.
Carton Contents
Parts included:
• Generator
• Wheel kit
• Storage cover
• Battery
• Battery charge cables
• Battery float charger
• Locking 30 Amp plug
• Two bottles of engine oil
• Three packets of fuel stabilizer
• Owner's manual
• Engine manual
If any of the above parts are missing or damaged, call the
generator helpline at 1–800–270–1408.
7000EXL Extended Life Generator
ELECTRIC START
Your unit is equipped with electric start capability but can
be started manually. If you choose not to use the electric
start feature, you do not need to connect the negative
battery cable.
Check Battery / Attach Negative
The sealed battery on the generator is fully charged and
pre–installed except for the negative (black) battery cable.
To install:
1.
2.
3.
Figure 1 — Negative Battery Connection
Battery Cable
Screw
4.
5.
6
Battery Wire
Cut off tie wrap securing loose end of negative (black)
cable.
Using an 8 mm socket wrench, remove screw, lock
washer and flat washer on negative battery terminal.
Slide lock washer, flat washer and negative battery
cable over screw (Figure 1).
Negative
Flat Washer
Lock Washer
Reattach screw to negative battery terminal and
tighten.
Verify that connections to battery and generator are
tight and secure.
Positive
Battery Cable