Bose Panaray System Digital Controller II Notice D'utilisation page 3

1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water or moisture.
6. Clean only with a dry cloth.
7. Do not block any ventilation openings. Install in
accordance with the manufacturer's instructions
8. Do not install near any heat sources, such as radia-
tors, heat registers, stoves or other apparatus
(including amplifiers) that produce heat.
9. Do not defeat the safety purpose of the polarized
or grounding-type plug. A polarized plug has two
blades with one wider than the other. A grounding-
type plug has two blades and a third grounding
prong. The wider blade or third prong are provided
for your safety. If the provided plug does not fit in
your outlet, consult an electrician for replacement
of the obsolete outlet.
10. Protect the power cord from being walked on or
pinched, particularly at plugs, convenience recep-
tacles, and the point where they exit from the
apparatus.
11. Only use attachments/accessories specified by the
manufacturer.
12. Use only with the cart, stand, tripod,
bracket or table specified by the man-
ufacturer or sold with the apparatus.
When a cart is used, use caution
when moving the cart/apparatus combination to
avoid injury from tip-over.
13. Unplug this apparatus during lightning storms or
when unused for long periods of time.
14. Refer all servicing to qualified service personnel.
Servicing is required when the apparatus has been
damaged in any way: such as power-supply cord or
plug is damaged; liquid has been spilled or objects
have fallen into the apparatus; the apparatus has
been exposed to rain or moisture, does not operate
normally, or has been dropped.
Important Safety Instructions
15. To prevent risk of fire or electric shock, avoid over-
16. Do not let objects or liquids enter the product – as
17. See product enclosure bottom for safety-related
18. No naked flame sources, such as lighted candles,
Information about products that generate
electrical noise
If applicable, this equipment has been tested and found to
comply with the limits for a Class B digital device, pursu-
ant to Part 15 of the FCC rules. These limits are designed
to provide reasonable protection against harmful interfer-
ence in a residential installation. This equipment gener-
ates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, this is no guarantee that interference will not
occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and
on, you are encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
• Connect the equipment to an outlet on a different circuit
• Consult the dealer or an experienced radio/TV techni-
Note: Unauthorized modification of the receiver or radio
remote control could void the user's authority to operate
this equipment.
This product complies with the Canadian ICES-003 Class
B specifications.
loading wall outlets, extension cords, or integral
convenience receptacles.
they may touch dangerous voltage points or short-out
parts that could result in a fire or electric shock.
markings.
should be placed on the apparatus.
receiver.
than the one to which the receiver is connected.
cian for help.
3