Technical Data; Noise & Vibration; Battery Information - Pattfield Ergo Tools PE-36B Traduction De La Notice Originale

technical Data

nominal voltage
max. torque
no load speed
torque setting
Battery capacity
tool holder
Battery charger input
Battery charger output
charging time
Sound pressure level (L
max. vibration emission (a
noise & Vibration
The values given in these instructions have
been measured in accordance with a stand-
ardized measurement procedure specified in
EN 60745 and can be used to compare tools.
It may be used for a preliminary assessment
of exposure.
warning! The vibration emission
during actual use can differ from the
declared total value depending on the use
of the tool.
88 EN
3.6 V
3 Nm (ISO 5393)
180/min
6 + torque deactivated
1300 mAh
6.35 mm
230-240 V~ / 50 Hz / 5W
5 V / 300 mA
3-5 hours
) < 70 dB(A)
pA
) 0.814 m/s
hd

Battery information

The battery is supplied partially charged. Com-
pletely charge the battery before using the tool
for the first time. The lithium ion battery can
be charged at any time without reducing its
service life. Interrupting the charging proce-
dure does not damage the battery.
The battery is protected against deep dis-
charging by the "Electronic Cell Protection
(ECP)". When the battery is empty, the tool is
switched off by means of a protective circuit.
Therefore do not press the on / off switch
after the machine has switched off automati-
cally. The battery can be damaged.
Due to the NTC temperature control, the bat-
tery can only be charged at temperatures be-
tween 0 °C and 45 °C.
If the temperature exceeds 70 °C during op-
eration the three battery power
will flash rapidly and the tool is switched off by
means of a protective circuit. Once the tem-
perature is between -10 °C and 70 °C, the tool
can be operated normally.
/ Uncertainty K = 1.5 m/s
2
check 1
2
7
LEDs