Troubleshooting - FULGOR F6RT24 Série Manuel D'utilisation Et D'entretien

Problem
Nothing works
Heating elements do not heat
properly
Heating elements cycle off
even when elements are
turned to their highest settings
Glass ceramic surface is see-
through or appears to be red
in color.
/RFN .H\ EORFNHG DIWHU ¿UVW
connecting or unresponsive
touch control.
18

Troubleshooting

Cause
Cooktop not connected to proper
electrical circuit.
Fuse is blown or circuit breaker is tripped.
No electricity to the cooktop.
Cooktop is in lockout mode.
Cooktop is connected to 120 volt power
supply.
Power supply connection is loose.
Improper cookware is being used.
Heating element temperature limiters are
temporarily shutting off the elements due
to exceeding the maximum allowable
temperature.
Under direct or bright lighting, you will
sometimes be able to see through the
glass and into the chassis due to its
transparent quality. You may also notice a
red tint under these conditions
:KHQ ¿UVW FRQQHFWLQJ HOHFWULFDOO\ RU
after a power failure, any direct strong
light over the sensor area may affect the
touch control functionality.
Use & Care Manual
Possible Remedy
Have electrician verify that the proper
rated cooktop voltage is being supplied
to the cooktop. Have electrician replace
fuse or reset circuit breaker.
Have electrician check your power
supply.
Unlock cooktop.
Have electrician connect cooktop to the
proper rate cooktop voltage.
Have electrician tighten the connections
at the junction box.
Select proper cookware as outlined in
the Cooktop Operation section of this
manual.
This is a normal operating condition,
especially during rapid heat-up
operations. The element will cycle back
on automatically after it has cooled
sufficiently.
These are normal properties of black
ceramic glass panels.
When powering on the unit make sure
that no strong light is shining
direct over the touch control zone, it
can compromise the start-up sensor
calibration resulting in an unresponsive
touch control.
ENGLISH