Stands; Connecting To The Amplifier - quadral aurum Notice D'utilisation

Rear speakers
Whether you direct the rear speakers toward the
listening position is a matter of taste. Also, many
listeners prefer the rear speakers to be positioned
above ear height. This can be achieved by mounting
the units on a sturdy wall bracket, a high speaker
stand, a sideboard or shelf.
For optimal front and rear speaker setup, quadral has suitable stands in its product range.
Should you have any questions, please contact us on tel.: +49 (0) 511 7904-0,
e-mail: ovs@quadral.com or info@aurumspeakers.com
Before connecting up the speakers to your hifi or surround sound system, please ensure that the amplifier/
receiver is switched off and its pilot light is not on. For connection, you will need a twin-core loudspeaker
cable for each speaker cabinet. Make sure these cables are sufficiently long and cut them to a length that will
subsequently enable you to lay them behind furniture or under the carpet where necessary. For cables more
than 5 m in length we recommend a cross-section area of at least 2.5 mm 2 per core in order to avoid any
unnecessary loss of output. To enable optimum contact, about 10 mm of the cores at each end of the cable
must be isolated, and thus bare.
For connection, the speakers are provided with colour-coded screw terminals on the back of the cabinet.
Loosen the screw terminals and feed the stripped end of the core into the hole that is now free. The two cores
of speaker cables have different colouring or shape for recognition. Connect the "+" core to the red, positive
terminal – the remaining core to the black terminal. Tighten the screws hand-tight. To ensure correct polarity,
check that the core connected to the red "+" terminal of the speaker is also the core that is connected to the
6

STANDS

CONNECTING TO THE AMPLIFIER

SCREW TERMINALS
> –
50 cm
FRONT
CENTER
SUBWOOFER
REAR
REAR
CENTER
REAR