Black & Decker DV7215EL Mode D'emploi page 6

ENGLISH
Features
This tool includes some or all of the following features.
1. On/off switch
2. Bowl release button
3. Charging indicator
4. Dust bowl
5. Dust collector
6. Charger socket
7. Charger
Assembly
Accessories (ig. A & B)
These models may be supplied with some of the following
accessories:
An Integrated brush tool (9) for furniture and stairs.
u
An Integrated crevice tool (10) for conined spaces.
u
The integrated brush tool (Fig. A)
Flip down the brush tool (9) at the end of the dust collec-
u
tor.
The integrated crevice tool (Fig. B)
Extend the crevice tool (10) by pulling the crevice tool (10)
u
until it locks into position.
Retract the crevice tool (10) by pressing the area (11) and
u
pushing the crevice tool (10) back into the dust collector
(5).
Installation
Wall Mounting (ig. C)
The product can be attached to a wall to provide a convenient
storage and charging point for the appliance.
When ixing to a wall, make sure that the ixing method is
suitable for the wall type and is appropriate to the weight of
the appliance.
Mark the location of the screw holes (within reach of an
u
electrical outlet for chargeing the vac while it is on the wall
bracket).
Insert the charger cord into the curved slot in the wall
u
mount bracket leaving approximately 8-9 inches excess.
Hang the appliance on the wall by placing the opening
u
on the base of the vac over the hooks in the wall mount
bracket.
6
(Original instructions)
Use
Before irst use, the battery must be charged for at least 4
u
hours.
Charging the battery (Fig. D)
Make sure that the appliance is switched off. The battery
u
will not be charged with the on/off switch in the on posi-
tion.
Plug the jack plug of the charger (7) into the charging
u
socket (6) of the appliance.)
Plug in the charger. Switch on at the mains. The charging
u
indicator (3) will be lit.
Leave the appliance to charge for at least 4 hours.
u
While charging, the charger may become warm. This is
normal and does not indicate a problem. The appliance can
be left connected to the charger indeinitely. The charging
indicator (3) will be lit as long as the appliance is connected to
the plugged-in charger.
Warning! Do not charge the battery at ambient temperatures
below 10 °C or above 40 °C.
Switching on and off (ig. E)
To switch the appliance on, slide the on/off switch (1)
u
forward to position 1.
To switch the appliance off, slide the on/off switch (1) back
u
to position 0.
Rotating the dust collector (ig. F)
The nozzle can be rotated for better access in tight spots.
Press the rotation release catch (12).
u
Rotate the nozzle to the left or right until it clicks into
u
place.
Optimising the suction force
In order to keep the suction force optimised, the ilters must be
cleared regularly during use.
Emptying and cleaning the product
Emptying the dust bowl (ig. G)
Press the release latch (13) and pull the dust collector (5)
u
straight off.
Empty the contents of the bowl.
u
To replace the dust collector, place it back onto the handle
u
until it "clicks" irmly into position.