Attaching The Toroidal Ferrite Core To The Power Cord Of The Subwoofer - Samsung HT-ES8200 Mode D'emploi

2. Place the Wall Bracket on the wall so that the arrow side faces upward and use four screws
(not included) to fix it on the wall. Drive the screws into a stud or into mollies for secure support.
After the Bracket-Set is installed, slide and insert the Blu-ray Disc product into the appropriate slots
of the Wall Bracket.
| NOTE |
\ Screws for the wall bracket are not included. Purchase screws (and mollies) appropriate for your type of wall.
\ Make sure that the product is installed standing on the ground or hanging on the wall. Laying down the product on the
ground may cause the product malfunction.

Attaching the Toroidal Ferrite Core to the Power Cord of the Subwoofer

If you attach a Toroidal ferrite core to the power
cord of the Subwoofer, it will help to prevent RF
interference from radio signals.
1. Pull the fixing tab of the Toroidal ferrite core to
open it.
2. Make a loop twice in the power cable of the
subwoofer.
3. Attach the Toroidal ferrite core to the Subwoofer
power cord as the figure shows and press it until it
clicks.
HT-ES8200_XU_0425.indd 17 HT-ES8200_XU_0425.indd 17
AUX IN
DIGITAL ONLY FOR
FM ANT
AUDIO IN UPDATE
FRONT
(OPTICAL)
HDMI OUT HDMI IN 1 HDMI IN 2 SYSTEM CABLE
FRONT
SPEAKERS OUT
SPEAKER IMPEDANCE : 3
DIGITAL
ONLY FOR
AUDIO IN UPDATE
(OPTICAL)
English
2012-04-25 오전 11:14:15 2012-04-25 오전 11:14:15
17
|