Soft Deep Freezing And Conservation; Pre-Cooling - Whirlpool ACO D 103 Instructions Pour L'installation, L'emploi Et L'entretien

EN
Operate as indicated to start the cycle:
• Press and release the deep freezing key (the LED blast chilling, deep freezing, hard and probe will flash).
• Pressing again the deep freezing key the system passes from the temperature control to the time control (in this
case, the probe led turns off and the time led lights up).
• At this point, to start the cycle press and release the start/stop key.
• The system starts a test to verify the correct insertion of the probe. If the test is successfully completed the
cooling cycle will start.
6.3D SOFT DEEP FREEZING AND CONSERVATION
The soft deep freezing and conservation cycle is divided into the following two phases:
• Deep freezing soft phase
• Deep freezing
• Conservation
On conclusion of a phase, the device passes automatically to the next.
Operate as indicated to start the cycle:
• Press and release the deep freezing key (the LED blast chilling, deep freezing, hard and probe will flash).
• Press and release the hard/soft key (the hard led turns off).
• At this point, to start the cycle press and release the start/stop key.
• The system starts a test to verify the correct insertion of the probe. If the test is successfully completed the
cooling cycle will start.
6.3E PRE-COOLING
Each cooling cycle can be preceded by a precooling phase.
Operate as indicated to start pre-cooling:
• Hold the blast chilling key down for 1 second: (the pre-cooling LED will flash).
• The pre-cooling phase will start and continue until the temperature for pre-cooling is reached.
• When the cell reaches the expected temperature, the pre-cooling led stops flashing and remains fixed.
• The buzzer is activated for one second.
• Pre-cooling continues until a cycle is started. To
stop pre-cooling:
• Hold the blast chilling key down for 1 second or start a cycle.
20