Publicité
Les langues disponibles
Les langues disponibles
User Manual
Operation buttons:
•
Pressing "OK/MENU" button enters the OSD. Then navigate using the 4-way arrow buttons.
A new OSD setting is confirmed by pressing the "OK/MENU" button.
•
Pressing "EXIT/AUTO" will exit the OSD. Press "EXIT/AUTO" for 5 seconds to auto
switching on/off. When the button LED light is on, this means auto switching is on.
•
Pressing the "MIC-/+" button decreases or increases MIC volume. Pressing the "VOL+/-"
button increases or decreases "Master volume".
•
Pressing both "MIC-" and "MIC+" buttons simultaneously will reset the HDMI/HDBT output
resolution to 720P 60Hz.
•
Pressing both "VOL-" and "VOL+" buttons simultaneously will lock / unlock the front panel,
these two button LEDs will light on when the front panel is lock on.
Rear Panel:
Control ports:
•
LAN: This port is for Web GUI control; connect to an active Ethernet link with an RJ45
terminated cable.
•
RS-232: Serial control port, connects with a control device to control the switch or it can be
used as an extender to control another device connected with the HDBaseT receiver.
•
IR IN: Connect the IR receiver cable to receive IR signals sent by the IR remote or this can
be used to extend IR signals to the HDBaseT receiver.
•
IR OUT: Connect the IR emitter cable. Used for controlling the local source device or the
switch.
•
CONTACT IN: This input control is reserved for direct source selection. Connect the ground
pin (marked as
on panel) with following pin number for individual source selection.
English
Publicité
