Velleman DVM832 Mode D'emploi page 7

• Never exceed the limit value for protection. This limit
value is listed separately in the specifications for each
range of measurement.
• Do not touch unused terminals when the meter is
linked to a circuit which is being tested.
• Set the range selector at its highest position if the
intensity of the charge to be measured is unknown
beforehand.
• Disconnect the test leads from the tested circuit before
rotating the range selector in order to change
functions.
• When carrying out measurements on a TV set or
switching power circuits, always remember that the
meter may be damaged by any high amplitude voltage
pulses at test points.
• Always be careful when working with voltages above
60 VDC or 30 VAC rms. Keep your fingers behind the probe
barriers at all times during measurement.
• Never perform resistance, diode or continuity
measurements on live circuits. Make sure all capacitors
in the circuit are depleted.
6. General Description
Refer to the illustration on page 2 of this manual:
1. Display (max. 1999 counts, max. 3 ½ digits,
dimensions: 47 x 15 mm)
With low-battery indication
2. Rotary switch for manual range selection
This switch is used to select functions and desired
ranges as well as to turn the meter on/off.
3. "VmA" jack
Insert the red (positive) test lead in this connector to
measure voltage, resistance and current (except
10 A).
4. "COM" jack
Insert the black (negative) test lead.
V. 05 – 05/01/2022
DVM832
7 ©Velleman Group nv