Konig & Meyer Omega-E Mode D'emploi page 125

List of error codes
Error code Last name
E01 Loss of position
E08 Unexpected reset
E09 LIN error
E10 Power fault
E11 Channel detection
E12 Position difference
E13 Short circuit
E14 Checksum error
E15 Power limit reached
E16 Key error
E17 No safety
E18 Initialization plug missing
E23 No channel 1
E24
Channel 2 missing
E25
No channel 3
E26
No channel 4
E27 No channel 5
E28 No channel 6
E29 Channel 1 type
E30 Channel 2 type
E31 Channel 3 type
E32 Channel 4 type
E33 Channel 5 type
E34 Channel 6 type
E35 Channel 1 pulse
E36 Channel 2 pulse
E37 Channel 3 pulse
E38
Channel 4 pulse
E39 Channel 5 pulse
E40 Channel 6 pulse
E41 Channel 1 overload
E42 Channel 2 overload
E43 Channel 3 overload
E44 Channel 4 overload
Table-style keyboard stand »Omega-E«
Item no.: 18800-000-55 / 18800-010-55
Appendix
Description
Initialize the system.
Unexpected reset due to software error or exter-
nal reset.
Error on the LIN bus.
Power fault or power regulator set to under 10%.
Number of connected channels has changed
since the last initialization.
Difference between min. and max. position of a
reference has changed since the last initializa-
tion.
Short circuit was detected during operation.
Error in determining position, new
initialization required.
The power limit of the control unit has been
reached; excessive load on the system.
Incorrect key combination pressed on the control
console.
Safety function did not permit operation. (Can
arise with the "old" control element with display
prior to approx. 04/2013.)
Special hardware required to change the number
of channels.
No drive
Drive type has changed since the last initializa-
tion or is not the same as the others.
Pulse error
Overload upwards. Possibly no signal due to a
disconnected cable
10
40