Glossary; Duty Cycle; Accessories - Ex-Cell E7540 Guide D'utilisation

Model No.
Running Horsepower
Voltage-Single Phase
Minimum Branch Circuit Requirement
*Fuse Type
Air Tank Capacity, Gallons
Approximate Cut-in Pressure
Approximate Cut-out Pressure
SCFM @ 100 psig
SCFM @ 175 psig
Become familiar with these terms before operating the unit.
CFM: Cubic feet per minute.
SCFM: Standard cubic feet per minute; a unit of measure of air delivery.
PSIG: Pounds per square inch gauge; a unit of measure of pressure.
Code Certification: Products that bear one or more of the following marks: UL,
CUL, ETL, CETL, have been evaluated by OSHA certified independent safety
laboratories and meet the applicable Underwriters Laboratories Standards for
Safety.
Cut-In Pressure: While the motor is off, air tank pressure drops as you continue
to use your accessory. When the tank pressure drops to a certain low level the
motor will restart automatically. The low pressure at which the motor automati-
cally restarts is called "cut-in" pressure.
Cut-Out Pressure: When an air compressor is turned on and begins to run,
air pressure in the air tank begins to build. It builds to a certain high pressure
before the motor automatically shuts off - protecting your air tank from pressure
higher than its capacity. The high pressure at which the motor shuts off is called
"cut-out" pressure.
Branch Circuit: Circuit carrying electricity from electrical panel to outlet.
To Lock Out Power: Place a lock on the line power switch so no one else can
turn on the power.
This air compressor pump is capable of running continuously. However, to pro-
long the life of your air compressor, it is recommended that a 50%-75% average
duty cycle be maintained; that is, the air compressor pump should not run more
than 30-45 minutes in any given hour.
Accessories for this unit are available at the store the unit was purchased.
A18791
SPECIFICATIONS

GLOSSARY

DUTY CYCLE

ACCESSORIES

8-ENG
E7540
6.0
240V
30 amps
Time Delay
80 ASME, Vertical
140 PSIG
175 PSIG
14.0
13.5