Bluetooth - Kicker Bullfrog BF400 Manuel D'utilisation

Bluetooth

The KICKER BF400 supports audio input via Bluetooth transfer protocol. It will remember and
auto-connect with up to 5 audio devices. Use a software reset to wipe the auto-connect list,
or pair more devices to bump the last one off.
Enter Pairing mode by performing a long press (1 second) of the SOURCE button while
the speaker is powered on.The Blue source LED will fl ash while in pairing mode for up to 2
minutes, then time-out. You may also exit pairing mode by pressing the SOURCE button.
When the BF400 enters Bluetooth
mode, it will automatically begin to
search for and connect with the last
connected device. If that device is
not found, it will continue to search for
the other saved connections until a
connection is established.
When in Bluetooth Pairing mode,
the Bullfrog will display as "BF400
KICKER" on your Bluetooth device.
Double-Kick Mode:
Double-Kick allows you to play your audio through two Bullfrogs. One Bullfrog, the Primary, will
broadcast the audio to the Secondary Bullfrog. Audio and EQ settings applied by the Primary
Bullfrog, or KICKER Connect app, will be mirrored on the Secondary Bullfrog. Double-Kick
mode is compatible with all audio input sources. You may enter Double-Kick mode by using
the KICKER Connect app, or manually with the following button sequence.
1. Pair Bluetooth device with Primary Bullfrog
2. Setup Primary Speaker
Press & Hold Play/Pause and '+' on
Primary Bullfrog. The battery LEDs will
indicate Primary mode
pattern.
Primary
When successful, the Primary Bullfrog should have a solid Blue LED. The Secondary Bullfrog
should have all input source LEDs solid. Any volume changes made on one Bullfrog will effect
the other. Press the SOURCE button, or turn the Bullfrog off, to exit Double-Kick mode.
6
with an inside-out
2.
3. Setup Secondary Speaker
Press & Hold Play/Pause and '–' on
Secondary Bullfrog. The battery LEDs will
indicate Secondary mode
outside-in pattern.
3.
1S
1S
1S
=
with an
Secondary