Modifying The Room Temperature; Modifying The Power - Palazzetti PREMIUM UI Mode D'emploi

Ready!
After a few seconds the start screen appears:
20,0
25,8 °C
Attention: Automatic ignition: the device
is equipped with an automatic device that
allows pellet ignition without the use of
other traditional ignitors.
Hazard: Do not manually ignite the device
if the automatic ignition system is faulty.
Attention: During the first ignition of the
device, unpleasant odours or fumes may be
generated due to the evaporation or drying
of certain materials used. This phenome-
non will gradually disappear.
During the first ignitions, it is advisable to
keep the premises well ventilated.
"Hermetic" series devices:
Do not leave the fire box door open for prolonged
periods whenever you open it to avoid setting off an
audible alarm when the closure sensor detects the
door open status.
44

4.1.1 Modifying the room temperature

By changing this value, the desired room tem-
perature is set, detected directly by a sensor
located on the device.
OFF
Fig. 59
°C
To change the temperature press icons
The value can be set between 6°C and 51°C.

4.1.2 Modifying the power

The power defines the quantity of heat produced
by the device and therefore also directly affects
consumption.
AIR
Power
Fig. 60
5
TIMERS
To change the power level press icons
The value can be set between 1 (minimum) and
5 (maximum).
20,0
25,8 °C
Fan
4
STATS SETTINGS TIPS
004778600 - 21/10/2020
°C
AIR
Fig. 61
or :
START
Fig. 62
or :