Facom E.LM30 Notice Originale page 8

Contents
• User Safety
GB
• Battery Safety
• Setup (Load Batteries)
• Operation
• Protecting the Environment
• Guarantee
• Specifications
• Error Codes
Retain all sections of this manual for future
reference.
User Safety
WARNING:
Carefully read the Safety Instructions and
Product Manual before using this product. The
person responsible for the product must ensure
that all users understand and adhere to these
instructions.
WARNING:
The following label information is placed on
your laser tool to inform you of the laser class
for your convenience and safety.
The FACOM E.LM30 tool emits a visible laser beam,
as shown in Figure A. The laser beam emitted is Laser
Class 2 per IEC 60825-1 and complies with 21 CFR
1040.10 and 1040.11 except for deviations pursuant to
Laser Notice No. 50, dated June 24, 2007.
WARNING:
While the laser tool is in operation, be careful
not to expose your eyes to the emitting laser
beam (red light source). Exposure to a laser
beam for an extended time period may be
hazardous to your eyes. Do not look into
the beam with optical aids.
WARNING: To reduce the risk of injury, user
must read the Product User manual, Laser
Safety, and Battery Safety manuals.
8
Battery Safety
WARNING: Batteries. can explode or leak
and can cause serious injury or fire. To reduce
the risk:
ALWAYS follow all instructions and
warnings on the battery label and package.
DO NOT short any battery terminals.
DO NOT charge alkaline batteries.
DO NOT mix old and new batteries.
Replace all of them at the same time with
new batteries of the same brand and type.
DO NOT mix battery chemistries.
DO NOT dispose of batteries in fire.
ALWAYS keep batteries out of reach of
children.
ALWAYS remove batteries if the device will
not be used for several months.
NOTE: Ensure that the recommended
batteries are used.
NOTE: Ensure the batteries are inserted
in the correct manner, with the correct
polarity.
Setup (Load Batteries)
1.
Locate the battery compartment latch on the back
of the tool (Figure B #2).
2.
Using your finger, pull the latch to unlock and open
the battery door (Figure C #1 and #2).
3.
Insert two AAA batteries, making sure to position
the - and + ends of each battery as noted inside the
battery compartment (Figure C #3).
4.
Make sure the pins at the bottom of the battery
door are inserted into the notches in the battery
compartment, and push the door down until it snaps
into place.
When the tool is ON, the battery level appears in the
display window (Figure E #1).