Name Of Parts - Olympus PPO-E02 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 19
1

Name of Parts

PPO-E02 main body
Silicon O-ring (POL-E101)
Front cap
Rear cap
Zoom gear
Grease for silicone O-ring
Pick for O-ring removal
2
Mounting the PPO-E02 on the Waterproof Case
This section describes how to mount
this product on the PT-E series case.
Before mounting, check that no for-
eign matter is attached to the O-rings,
the port mount thread on the PT-E
series case, or the O-ring contact sur-
faces. Apply a thin layer of the provid-
ed silicone O-ring grease.
Align the threaded section of the PPO-E02 with the port mount thread on the PT-E series case.
Hold the PT-E series case firmly with one hand, hold the main body of the PPO-E02 with your other
hand and screw it into the PT-E series by turning the PPO-E02 clockwise.
Resistance increases as the PPO-E02 is screwed in more deeply. However, be sure to screw it in all the
way until there is no gap visible below the threaded section of the PPO-E02.
Grease applying surface on O-rings
Threaded
section
O-ring
O-ring contact surfaces
Port mount thread
E-2
Screw in until
there is no gap.

Publicité

Table des Matières
loading

Table des Matières