afriso Unitel Notice Technique page 14

5.3 Installing capillary line
14
Fig. 3: Capillary line with a steady slope without condensate trap
Fig. 4: Capillary line without a steady slope with condensate trap
If no separate gauge connection socket is provided on the tank, it is
possible to combine a number of capillary lines by connecting a Eu-
roflex 3 combination fitting to a G1"-socket on the tank.
1. Fix standpipe such that the lower end of the capillary tube ends
approx. 2 cm above the lowest point of the tank bottom.
2. Install capillary line with a steady slope towards the tank, avoid-
ing any kinks or possible water traps in the line.
1 Fuel draw-off line
2 Euroflex 3
3 Capillary tubing
4 Unitel
5 Stand pipe
6 Distance piece
1 Fuel draw-off line
2 Euroflex 3
3 Capillary tubing
4 Condensate trap
5 Unitel
6 Stand pipe
7 Distance piece