Beaba UPDOWN Instructions De Montage page 7

3
Position the large tubes (A) by pressing on the spring buttons and inserting them in the small tubes (B). The three holes on the
large tube must be facing towards the inside of the bouncer.
4
Remove the handles (E) by pressing on the spring button and unfold the seat structure (G) following the instructions for setting
the incline.
Place the seat structure (G) on the tubes. Attention! Always ensure that the seat structure is facing the right way (seat on the
same side as the stabiliser).
5
Press on the locking buttons on each side of the seat structure and release at the desired position.
6
Position the handles (E) by pressing down on the spring buttons and inserting them in the large tubes (A).
Place the cover (H) on the seat structure (G). To do this, fold the seat structure, place over the back and then over the seat.