Radiometrix CTR44 Manuel D'emploi page 17

ENGLISH
L) Programming the card
Step-by-step logic
JP3 JP2 JP1
JP1 - jumper not inserted
JP2 - no effect
JP3 - no effect
Automatic closing logic
JP3 JP2 JP1
JP1 - jumper inserted
JP2 - no effect
JP3 - no effect
Immediate closing logic
JP3 JP2 JP1
JP1 - no effect
JP2 - no effect
JP3 - jumper inserted
Photo-stop logic
JP3 JP2 JP1
JP1 - no effect
JP2 - jumper inserted
JP3 - no effect
Remote controls codes self-learning
Press the P1 push-button once to insert a Start code. Each time the push-button is pressed, the
led DL1 flashes in acknowledgement. When the led is lit with a fixed light transmit the code to
be learn by means of the radio-command.
Erasing all stored codes
Press push-button P1 until the led LD1 goes off (about 10 seconds).
Setting the pause time
Press push-button P3 until the led DL1 lights. Let the desired pause time pass, then press
push-button P3 again (the led goes off).
Setting the work time
Press push-button P2 until the gate starts opening. The opening limit switch stops the gate
when it is completely opened. If no opening limit switch is connected to the motor, it will be
necessary to press the P2 key again to stop the motion. After about 1 Second of pause the gate
starts closing automatically until it will reach the closing limit switch. If no closing limit switch is
connected to the motor, it will be necessary to press the P2 key again to stop the motion.
17