Installation; General Characteristics - Radiometrix CTR44 Manuel D'emploi

C) – Installation
1) Open the cover and check that the electronic unit is in good order. In case of doubt do not install the unit and ask for the intervention of
qualified personnel. The container's accessories (screws, round seal, cable glands) must not be left within the reach of children since they are
a potential danger.
2) Check that the electronic unit is properly fixed to its box. If not, tighten all screws or provide the missing screws.
3) Place the unit near the gate so that the system connection wires' length is reduced to the minimum.
Caution: For the unit's correct operation the wires connected to it must not be longer than 10 metres.
4) For increased weather protection we recommend to place the unit under a roof or, even better, in an enclosure having two side walls.
Wherever possible, it is advisable to install the unit at a minimum 1,5 mt level above the ground to keep it out of the reach of children.
5) Before proceeding to assembly place the container so that the side fitted with the cable glands is directed towards the ground.
Caution: Do not assemble the container on wood surfaces.
6) Lift the mobile portion of the connector and proceed to connect the unit wires as described in the following chapters.
D) - General characteristics
Power regulator
The electronic unit is pre-set for the optional connection of an accessory card called "power regulator". By means of this card the power supplied to
the motor can be reduced.
Caution: In case failure or anomaly of the power regulator card the motor may operate at their maximum power value. This is why n° 7 note
in the previous chapter "limits to use" must absolutely be put into practice.
Start up to maximum power
When the motor starts the unit supplies the maximum power value for approx. 1 sec. Subsequently the unit's power regulator card, if present,
operates. This particular feature allows to overcome the high negative torque at the motor start.
Radio-receiver
The electronic unit contains a radio-receiver allowing remote control of the gate by means of the radio transmitter. The radio receiver operates with a
self-learning logic and can store up to 12 different codes from the radio-commands. The memory contents is preserved in absence of power supply
The memory contents may be erased (total cancellation).
Blinker
The electronic card supplies an on/off control (flashing light) to the lamp. The logic of the blinking allows displaying the gate's operating.
Quick flashing light : it signals the opening phase
Slow flashing light : it signals the closing phase
Immediate closing
This procedure can be enabled or excluded. It is usually employed when the gate must close as soon as the vehicle has passed the optical barrier
(photo-cell) placed along the way.
Caution: This procedure must be excluded when the gate opening is controlled by a clock.
12
ENGLISH
.