17. EC STANDARD COMPLIANCE MARKING
EC standard compliance marking certifies that the product stipulated below:
Complies with the basic requirements of European Directive 1999/5/CE of 09/03/1999, known as
the "R&TTE Directive" concerning RF equipment and telecommunications terminals with respect
to :
Health and safety protection of the user and all other persons,
EMC protection
Conforms to the following harmonized standards:
EN 60950-1
RSS-Gen
RSS-210
ANSI
C63.4
(03)
18. FCC COMPLIANCE STATEMENT
This device complies with part 15 of the FCC rules and with Industry Canada license-
exempt RSS standard(s). Operation is subject to the following two conditions:
(1). This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limts for a class B digital device,
pursuant to part 15 of the FCC Rules.
NOTE: THE GRANTEE IS NOT RESPONSIBLE FOR ANY CHANGES OR MODIFICATIONS NOT EXPRESSLY
APPROVED BY THE PARTY RESPONSIBLE FOR COMPLIANCE. ANY CHANGES OR MODIFICATIONS COULD
VOID THE USER'S AUTHORITY TO OPERATE THE EQUIPMENT.
Electrical safety of data processing equipment including electrical office
equipment. Issue dec 2001
Issue 3, December 2010
General Requirements and information for the certification of Radio
Apparatus
Issue 8, December 2010
Licence-exempt Radio Apparatus (All Frequency Bands) :
Category I equipment
Methods of measurement of Radio-Noise
Emissions from low-voltage Electrical and Electronic Equipment in the
Range of 9 KHz to 40 GHz
V2 CLESS – NOTICE D'UTILISATION - USER MANUAL v1.0
23