Leveling Refrigerator; Proper Air Circulation; Door Alignment - Haier HA10TG21SW Guide De L'utilisateur

INSTALLATION INSTRUCTIONS

LEVELING REFRIGERATOR

• Your refrigerator has two leveling legs that are located in the front bottom
corners of your refrigerator. After properly placing your refrigerator under its
final position, you can level your refrigerator.
• Leveling legs can be adjusted by turning them clockwise to raise your
refrigerator or by turning them counterclockwise to lower your refrigerator.
The refrigerator door will close easier when the leveling legs are extended.
Raise

PROPER AIR CIRCULATION

• To ensure your refrigerator works at the maximum efficiency it was designed
for, you should install it in a location where there is proper air circulation,
plumbing and electrical connections. Your refrigerator is not designed to
• Do not install your refrigerator in any location not properly insulated or heated,
e.g. garage, etc. Keep out of direct sunlight and away from heating sources such
as radiators, heaters, and cooking appliances.
• The following are recommended clearances around the refrigerator:
Sides...............1" (25 mm)
Back..................2" (50mm)

DOOR ALIGNMENT

Freezer Door
1. Remove the top hinge cover. (Fig 1.)
2. Loosen the top hinge screws using a
hex-head screwdriver.
3. Adjust the door or put a spacer in
between and then tighten the screws.
4. Replace the top hinge cover.
10
Top....................1" (25 mm)
Hinge
Cover
Fig. 1
Lower
Top
Hinge
49-60796