Shure AD610 SHOWLINK Guide De L'utilisateur page 9

Networking
Networking the access point using a DHCP-enabled router automatically assigns an IP address, simplifying network setup. The network connection
allows the access point to share data with networked components and enables wireless control of the transmitters. To manually assign an IP address to
the access point, use Wireless Workbench 6.
Reset Option
Pressing the reset button located on the bottom of the housing restores the access point to the following settings:
• IP Address Mode = DHCP
• Channel Agility = Enabled
• Device ID = AD610
• Device Association Tables will be cleared
Positioning the Access Point
• Provide a clear line of sight between the access point and transmitters. Mount the access point on a microphone stand or wall to elevate above
obstructions
• Position the antennas vertically for optimal performance. The swivel joint on each antenna allows a wide range of positioning to maintain a vertical
alignment
• If possible, move access point farther from other 2.4 GHz devices
Microphone Stand Mount
Control and Configure the Access Point with Wireless Workbench 6
Wireless Workbench 6 adds the following configuration and networking options for the access point:
• Edit Device ID
• View connected transmitters
• View transmitter capacity
• Disable channel agility for troubleshooting
• Set IP Address Mode: DHCP or Manual
• Set IP Address: Edit in Manual Address Mode
• View and set subnet mask
• View MAC address
Tip: The text color of the Device ID for each transmitter in the Connected list indicates Link Quality:
• Green = Excellent
• Yellow = Good
• Red = Marginal
Hovering the cursor over the Device ID displays Link Quality ranked from 5 to 1.
Reset Button
Horizontal Mount
9
PUSH
Wall Mount