Güde Profi M Traduction Du Mode D'emploi D'origine page 7

Faulty and/or disposed of
electrical/electronic appliances to
be collected by authorised salvage
places.
Packaging:
Protect from moisture
Technical Data:
Unit connection
Nozzle diameter
Weight
Assigned Use
This spray gun is lightweight pneumatically driven, a
varnishing gun for DIY and professional purposes. It is
suitable for varnishing mid-sized areas and minor repairs. The
paint is sprayed with a stream of air very finely and applied on
the article to be sprayed. .
The spray application may be adjusted owing to setting of the
circular and wide beam. The airhead may be shifted vertically
or horizontally when the broad beam is adjusted for larger
areas.
Residual Hazards and Protective Action
Materials and Other Substances Hazard
Contact-aspiration
When the paint articles are formed in large quantity,
lungs may be impaired. Health-hazardous articles
emissions may form in result of operation without
exhaustion. Always wear a respirator. Ideally, provide for
exhaustion.
Insufficient local lighting
Insufficient local lighting represents considerable safety
hazard. Always provide for sufficient lighting when working
with the unit.
Disposal
Disposal instructions are given by pictographs on the unit or
packaging. For meaning of individual symbols refer to chapter
"Symbols on Unit."
Operator Requirements
The operator shall read the instruction manual carefully
before using the unit.
Keep Up
Operating pressure
Can
Qualification
No special qualification is required for use of the unit except
for detailed direction by a professional.
Minimum Age
Only persons above 16 years of age are allowed to work with
the unit. .
Exempted from the provision is the use of the juvenile
trainees if they work in the course of their professional training
with an aim to obtain the skill under trainer supervision.
Training
Use of the unit requires adequate lesson by a professional or
the use of the manual only. Special training is not required.
Technical Data
Connect threading :
Operating pressure :
Air consumption :
Can:
Nozzle Ø :
Pressure outlet nozzle:
Approximate weight :
Dimensions L x W x H (mm): 110 x 60 x 250
EAN:
Ordering No.
Transportation and Storage
• Clean the unit thoroughly for any longer storage
Assembly and Initial Operation
The spray gun is fully assembled.
Operation
Never spray foodstuff or chemicals!
The paint can and air hose must be attached to the spray gun
firm and tight.
The optimum air pressure for varnishing is 3 – 3.5 bar subject
to viscosity and the paint process condition (to be found out if
necessary)
The optimum spray application is at a distance of 15 – 20 cm
approximately. Too small distance and too fast or too slow
moves make the spray application poor.
Tip: Make a test spray on a piece of cardboard before every
application. .
The thickness of application will
differ too much when rocking!
Vzdálenost při stříkání
začátek
stříkací
dráhy
BADLY
Distance at spraying
Spraying line beginning
WRONG
¼ "
2 – 4 bar
141 l/min.
100 ml/PVC
0,8 mm
1,4 bar
0,5 kg
4015671 02750 4
02750
Rovnoměrné nanášení.
Stříkání „mokrý do
mokrého".
stříkání
CORRECT
Spraying line
end
povolení