Power Supply; Handling And Use; Attaching The Polishing Cap; Removing The Polishing Cap - Nevadent NZPS 3 A1 Mode D'emploi

Power supply

♦ Use two 1.5 V batteries
proceed as follows:
1) Carefully twist the housing
side.
2) Insert the batteries
3) Push the housing
tighten it.
NOTE
► If the polishing effect diminishes, the batteries

Handling and use

This section provides important information about proper handling and operation of the
appliance.

Attaching the polishing cap

♦ Place the shaft of the polishing cap
cap clockwise while pressing down the catch

Removing the polishing cap

NOTE
► Remove the polishing cap
♦ Press down the catch

Polishing teeth

NOTE
► We recommend using the appliance in front of a mirror so that you can guide the ap-
pliance more confidently and avoid injuring your gums.
► It is normally sufficient to use the appliance twice a week. Use of the appliance does
not replace daily brushing with a toothbrush.
► Do not use appliance on your gums.
1) Add a little standard commercial toothpaste or a special polishing toothpaste to the
polishing cap
be polished.
2) Press the operating button
3) Move the appliance in a circular motion up and down to polish the tooth. Polish each
tooth for approx. 20–30 seconds.
4) Release the operating button
stops.
■ 6 │ GB │ IE │ NI
to operate the appliance. To insert the supplied batteries
anticlockwise off the hand element
. Pay heed to the correct polarity markings given on the housing
back onto the hand element
when it no longer delivers the required polishing result.
while turning the polishing cap
. Use the polishing cap
. The polishing cap
when you want to stop cleaning. The appliance
. Turn the housing
must be replaced.
onto the attachment thread
to tighten it.
to spread the toothpaste onto the area to
starts moving.
and place it to one
clockwise to
. Turn the polishing
anticlockwise.
NZPS 3 A1
.