Publicité
Les langues disponibles
Les langues disponibles
INSTRUCTIONS
The slicer is intended for slicing the common household amount of food and short-term operation. The
slicing duration should not exceed 10 minutes.
1.
Before plugging in the power cord, make sure the on/off switch is off .
2. Turn the control (3) to set the desired slice thickness. Lower numbers represent a thinner slice.
3.
Place the food to be sliced on the sliding tray and press (1) to activate the slicer.
4. Rest the food on the back side of the tray and begin to slice.
5.
Do not push excessively against the blade. With smooth movements, slide the tray back and forth. The
forward movement (slicing) should last 2 to 3 seconds, the backward movement shall last at least the
same, in any case 3 seconds at the very least.
6. Where possible, with respect to the size and shape of the food, always use the safety push guard.
7.
After slicing the food, switch off and unplug the device.
ATTENTION! The cutting blade can continue rotating for a short while after turning the device off . Do
not touch the cutting blade your hands!
GB
CLEANING AND MAINTENANCE
Cleaning the device
•
To prevent damaging electric components, do not immerse the device into water.
•
Before cleaning, always unplug the slicer and set the slice thickness control to position 0.
•
To prevent damaging the fi nish of the appliance, do not use abrasive agents for cleaning.
Cleaning the slicing blade
ATTENTION! The slicing blade is very sharp. Be very careful when cleaning, risk of serious injury. Do
not touch the blade when handling the slicing blade!
•
The slicing blade can be cleaned with a slightly moistened towel.
•
The area behind the blade occasionally requires cleaning as well. To access this
area, unscrew the centre blade screw with a coin or similar object. Turn clockwise
as the arrow on the screw indicates.
•
Be very careful when removing the blade. Pay attention to the blade when
cleaning the area behind the slicing blade.
•
After cleaning the blade, proceed in reverse order to return the blade to its place.
Tighten the screw only slightly, there is no need to tighten with brute force.
•
Apply the procedure above also when replacing the blade.
Storage
•
The sharp slicing blade can cause injury. Keep the device away from children.
•
Set the slice thickness control to position 0.
TECHNICAL SPECIFICATIONS
Nominal voltage: 230 V~ 50 Hz
Nominal input power: 150 W
KB = 10 min. (maximum cutting duration)
Noise level: < 78 dB
The appliance complies with the regulation so the EEC 82/499 guideline for eliminating the undesired
interference from radio communication
20
Publicité
