Installing The Devices; Cooling And Ventilating; Moisture Control; Operating The Devices - Heylo TD 300 Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

3. Installing the devices

At least one turbo dryer must be installed in each room to dry out a building. Air is to be produced on
three sides. Please make sure that all wet surfaces are exposed to air flow.

4. Cooling and ventilating

Overheated rooms can be cooled by the high volume air flow of a fan. Place the device on the floor or
another even surface for this purpose and let the air flow in from cooler areas or from outside.

5. Moisture control

If fans are used to increase evaporation in a building the air moisture usually also immediately
increases. When this happens, the movement of air becomes less effective and drying slows down. It
is therefore necessary that the fans are used together with a sufficient number of dehumidifiers. Air
moisture in rooms must be held at under 60% to keep formation of mould and mildew under control. If
possible air moisture in rooms should be under 45%. HEYLO dehumidifiers can be used for this
purpose.
The area to be dried must be separated from the rest of the building to improve the drying process.
Set heating or air conditioning to 20-27° C. If no dehumidifiers are available, ventilators should be used
in attics, kitchens and bathrooms to get rid of moisture. If the outside air is very dry, windows or doors
can be left slightly ajar.

6. Operating the devices

Connect the device to an earthed socket. Set the switch to turn on. Check for correct operation, before
the unit is left unsupervised.
Do not move or carry the fan during operation.

7. Repairs/maintenance

Attention: Always pull out the mains plug before maintenance and repair work.
INSPECTION OF THE ELECTRICAL SYSTEM: Check the electricity cable regularly for damages.
Remove the housing regularly and check the internal wiring for blank conductors, loose fittings and
discolouration. Take out and repair damaged cables if necessary.
CLEAN AIR INLETS: Fluff and other dirt that has collected at the air inlet must be removed. Remove
fluff, lint and dust from the fan wheel, motor and side covers with a vacuum or compressed air.
CLEAN HOUSING: Clean the housing with a mild detergent and water. Restore the original shine with
vinyl cleaner and polish, e.g. used for synthetic materials for vehicles.
EXTERNAL CHECKING: Check the external parts and make sure that they have been properly
installed. Look out for unusual noises.
ENGINE AND WIRING MUST REMAIN DRY: The turbo dryer cannot be cleaned with a water hose or
pressurised washing device to prevent electrical components from getting damaged. If electrical
components still get wet, they must be dried immediately.
EN
10

Publicité

Table des Matières
loading

Table des Matières