Low Voltage Cut Out, Drilling - Batavia 909 Notice D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

sunlight or any other heat source.
DO NOT force cool the pack in any way. Do not place in refrigerators
or freezers. When the battery pack has cooled down it can again
be used to operate the drill, as long as the load or the conditions
causing the original excessive temperature has been corrected.
Low voltage cut out
This tool is fitted with a low voltage cut out feature to assist in providing
a long life to the battery.
When the battery is close to the pre-set minimum low voltage level, the
power consumption LED will be red and the tool will turn off. You will
then need to insert either a fully charged battery pack into the drill or
recharge the existing battery pack.
Note:
Attempting to restart the tool without either recharging the battery
or installing another battery (with charge) will lead to drill restarting and
then stopping again, after only a few seconds of operation.
Drilling
DRILLING METALS
Always clamp sheet metal.
Support thin metal with a block of wood to avoid distorting it.
Use a punch to mark the centre of the hole.
Use a suitable lubricant for the material you are working on.
USE / FOR:
Oil / Steel
Turpentine or paraffin / Aluminium
Do not lubricate brass, copper or cast iron
DRILLING MASONRY
This drill is not designed for drilling masonry. Purchase or rent a
hammer drill.
DRILLING WOOD
Clamp a piece of scrap wood to the back of your work to prevent
splintering.
ALL DRILLING OPERATIONS
Mark off the centre of the hole using a centre punch or nail.
Don't force the drill, let it work at its own pace.
Keep the drill bit sharp.
Reduce pressure as the drill is about to break through the item
being drilled.
Touch_MA_multi_1404-30.indd 43
Original Instructions
WARNING!
through the workpiece, because the drill has a tendency to grab
and kick opposite to the direction of rotation, which could cause a
loss of control. If the operator is not prepared, this loss of control
could result in serious injury.
MAINTENANCE
CAUTION!
Always disconnect the device before performing any adjustment
or maintenance operation. If the supply cord is damaged, it must
be replaced by the manufacturer or its service agent in order to
avoid a hazard.
Disconnect from the power supply immediately if the supply cord
is damaged.
Take care not to expose this tool to the rain.
CLEANING
Avoid using solvents when cleaning plastic parts. Most plastic parts are
susceptible to damage from various types of commercial solvents and
may be damaged by their use. Use clean cloths to remove dirt, carbon
dust, etc.
STORING
Store the machine, operating instructions and where necessary the
accessories in the original packaging. In this way you will always have
all the information and parts ready to hand. Pack the device well or use
the original packaging in order to avoid transit damage. Always keep the
machine in dry place.
For Lithium-ion battery pack storage longer than 30 days:
Store the Lithium-ion battery pack where the temperature Is below
26°C and free of moisture.
Store Lithium-ion battery packs in a 30%-50% charged condition.
Every six months of storage, fully charge the Lithium-ion battery
pack.
Exterior may be cleaned with a cloth or soft non-metallic brush.
DISPOSAL
Do not dispose of power tools into household waste! According the
European Guideline 2012/19/EU for Waste Electrical and Electronic
Equipment and its implementation into national right, power tools that
are no longer usable must be collected separately and disposed of in an
environmentally correct manner.
43
Be prepared for binding when the bit break
GB
01-05-14 15:33

Publicité

Table des Matières
loading

Produits Connexes pour Batavia 909

Ce manuel est également adapté pour:

3113-210

Table des Matières