Example Of Installation On The Floor Mat Or On The Chassis; Replacing The Top Cover - Pioneer PREMIER PRS-D2200T Mode D'emploi

Example of installation on the floor
mat or on the chassis
1. Place the amplifier where it is to be
installed. Insert the supplied tap-
ping screws (4 mm × 30 mm) into
the screw holes. Push on the screws
with a screwdriver so they make
marks where the installation holes
are to be located.
2. Drill 2.5 mm (1/8 in.) diameter holes
at the point marked, and install the
amplifier, either on the carpet or
directly to the chassis.

Replacing the top cover

1. Align the unit and top cover, and
insert the screw.
• The cover can be installed in the desired
direction to match to the amplifier.
2. Tighten the screw with a 4 mm
hexagonal wrench
Tapping-screws (4 mm × 30 mm) Tapping-screws (4 × 30 mm)
Screw
Top Cover
Drill a 2.5 mm (1/8 in.) diameter hole
Floor mat or chassis
14