Signing On/Off The Remote Control - Miele DARC 6 Mode D'emploi

en - Signing on/off the remote control
The remote control must be signed on
so that it can be used.
Signing on and off must be done at the
same time on the cooker hood and the
remote control. Signing on/off mode
has to be accessed on the cooker hood
first, then on the remote control.
To access Signing on/off mode on
the cooker hood
 Press the run-on option control
515 for approx. 10 seconds until
the indicator for power level 1 lights
up.
 Then press in turn,
– the "" control (1 sensor)*,
– then the "" control (IS sensor)*,
– then the lighting control .
 Then access the Signing on/off mode
on the remote control immediately.
To access Signing on/off mode on
the remote control
 Press both arrow controls  at the
same time and hold for about 5 se‐
conds until the remote control LED
flashes.
 Press the lighting control .
12
To start the signing on procedure
 In Signing on/off mode press the ""
control (IS sensor)* on the cooker
hood first and then the "" control
on the remote control.
The search for a signal will start. The re‐
mote control LED will flash steadily.
After approx. 30 seconds the remote
control LED will flash on and off 4 times
at short intervals. The connection has
been established. The LED will go out
after a short while.
 Confirm signing on with the cooker
hood run-on option control 515. All
indicator lights will go out.
The remote control can now be used.
If you do not confirm your selection
within 4 minutes, activation will not take
place.
To cancel the signing on procedure
 If it is not possible to sign on the pro‐
cedure can be cancelled by pressing
the run-on option control 515 on
the cooker hood and on the remote
control.
 The signing on procedure must then
be repeated. To do this the cooker
hood and the remote control must
first be signed off.
To sign off
 In Signing on/off mode press the ""
control (1 sensor)* on the cooker
hood and then the "" control on the
remote control.
The remote control LED will flash stead‐
ily.