BabyGo Gosafe Car Seat Instructions De Montage page 21

Step 1: Place the child safety seat on the vehicle's seat ensuring it is firmly
pressed against the car seat backrest.
Step. 2: Thread the car seat belt in through the seat belt route slot in the
seat's plastic backrest furthest from the car's seat belt buckle , and then out
through the other seat belt route slot and fasten it into the seat belt buckle.
Step. 3: Check the webbing of the seat belt has not become twisted or
tangled and that the lap belt goes under the armrest and the diagonal belt
under headrest belt guide then goes over the red belt guide on the side of
the backrest.
Step 4: Place your knee on the base of the safety seat and grip the top piece
of seat belt webbing .Pull the webbing upwards to tighten the seat belt.
Step 5: Finish tightening the webbing by pulling the diagonal strap upwards
until there is no slack and the seat is held firmly in place.Now you can strap
your child into the seat.
Note: The vehicle seat buckle is not positioned in or in front of the specified
(labelled) belt guide of the child restraint system.
Make sure the seat belt has not become twisted.Also check that the cover is
not impeding the movement or fit of the seat belt webbing in any way.
To release your child seat follow the above instructions in reverse order.
The satificatory position of the adult safety-belt
buckle relative to the child car seat is as the FIG.
You can contact the child car seat manufacture
if in doubt about the point.
ADJUST THE HEADREST HEIGHT 15-25 kg
(approx. 3 years to 11 years)
According to children's different height, the head-
rest can be adjusted up and down.
Step 1: Put your left (or right) hand on the backrest.
Step 2: Pull the button with your another hand.
Step 3: Make sure that the position fits for your child.
To make sure that the position fits for your child.
Gosafe Car Seat
21