Refrigerator Use; Using The Controls; Adjustment - Whirlpool W10480704B Instructions D'installation

Complete the Installation
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
1. Plug into a grounded 3 prong outlet.
2. Flush the water system. See "Water and Ice Dispensers" in
the User Instructions or User Guide.
NOTE: Allow 24 hours to produce the first batch of ice. Allow
72 hours to completely fill ice container.

REFRIGERATOR USE

Using the Controls

The refrigerator and freezer controls are located on the dispenser
panel.
IMPORTANT: The display screen on the dispenser control panel
will turn off automatically and enter "sleep" mode when the
control buttons and dispenser lever have not been used for
2 minutes or more. While in "sleep" mode, the first press of a
control button will only reactivate the display screen, without
changing any settings.
Touch any control button on the dispenser panel to activate
the display screen. The home screen will appear as shown.
10
Adjusting the Controls
For your convenience, your refrigerator and freezer controls are
preset at the factory. When you first install your refrigerator, make
sure that both the refrigerator and freezer controls are still set to
"4," the recommended "mid-setting."
IMPORTANT:
Wait 24 hours before you put food into the refrigerator. If you
add food before the refrigerator has cooled completely, your
food may spoil.
NOTE: Adjusting the set points to a colder than
recommended setting will not cool the compartments any
faster.
If the temperature is too warm or too cold in the refrigerator or
freezer, first check the air vents to be sure they are not
blocked before adjusting the controls.
The preset settings should be correct for normal household
usage. The controls are set correctly when milk or juice is as
cold as you like and when ice cream is firm.
Wait at least 24 hours between adjustments. Recheck the
temperatures before other adjustments are made.
When adjusting set points, use the following chart as a guide.
CONDITION:
REFRIGERATOR too cold
REFRIGERATOR too warm
FREEZER too cold
FREEZER too warm /
Too little ice
The set point range is "1" (coldest) to "7" (least cold). When the
recommended "mid-setting" ("4") is selected, a check mark
appears next to the setting.
Refrigerator Control:
Press FRIDGE TEMP to view the current set point for the
refrigerator.
Press FRIDGE TEMP again to adjust the set point. The setting
will decrease by 1 with each press of the button, looping back
to "7" after reaching "1."
After 60 seconds of inactivity, any changes will be saved and
the display will return to the home screen.

ADJUSTMENT:

REFRIGERATOR Setting
one setting higher
REFRIGERATOR Setting
one setting lower
FREEZER Setting
one setting higher
FREEZER Setting
one setting lower