Transmitted Light Operation - Eschenbach 3320 Mode D'emploi

• Now slide the illumination unit holder side-
ways onto the accessory.
• Allow the illumination unit
the holder and then adjust the unit up for
illuminating the object.
• Finally, place the microscope head back
onto the table stand column and lock it with the securing wheel u.
Place the cap screw o back on the column and screw it down firmly.
• Insert the power adapter of the illumination unit into a properly installed
mains power socket.
• Activate the On/Off switch to switch the illumination unit
• After use, switch the illumination unit off by activating the On/Off switch.

Transmitted light operation

• Slide the illumination unit
located below the object bearer disc. Thereby, the bulb must be directed
upwards.
• For transmitted light operation use the supplied object bearer disc made
of glass.
• Insert the power adapter of the illumination unit into a properly installed
mains power socket.
s to snap into
s into the receiver opening f on the table stand
- 16 -
a on.