Hitachi PSC-6RAD Manuel D'installation page 7

1.
SAFETY SUMMARY
DANGER::
DO NOT pour water into the remote control switch (hereafter called "controller"). This product
is equipped with electrical parts.
If poured, it will cause a serious electrical shock.
WARNING:

DO NOT perform installation work and electrical wiring connection by yourself. Contact your
distributor or dealer of HITACHI and ask them for installation work and electrical wiring by
service person.
The specified cable should be used to connect room air-conditioner and adapter, and
controller and adapter.
If not it may result in an electricl shock or a fire.
CAUTION:
- DO NOT install the indoor unit, outdoor unit, controller and cable at such places as;
- Where there is oil vapor and the oil is dispersed
- Where the hot springs are near (in a sulfuric environment)
- Where generation, flowing, staying or leaking of flammable gas is detected
- Where the sea is near (in the salty environment)
- An acid or alkaline environment
- DO NOT install the indoor unit, outdoor unit, controller and cable within approximately 3
meters from strong electro-magnetic wave radiators such as medical equipment. In case that
the controller is installed in a place where there is electromagnetic wave direct-radiation,
shield the controller and cables by covering with the steel box and running the cable through
the metal conduit tube.
- In case that there is electric noise at the power source for the indoor unit, provide a noise
filter.
2.
INSTALLATION WORK
2.1. BEFORE INSTALLATION
Check the contents and the number of the accessories in the packing.
Double-face tape
With
1.8m
cable
each
1 piece of cover
The adapter for hiding the
110 x 40 x 3mm
1 Double-face tape
for attaching to the
wiring adapter
SAFETY SUMMARY
Ø3.0 x 10mm
2 connectors for H- 2 tapping screws for
LINK connection attaching to the wall
1
Ø3.1 x 16mm
2 screws for
attaching to the
wooden wall