Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Guided Tour - AF1 / AG1 Transmitters
Samson AirLine
3: 15 dB Pad - Move this switch in the direction of the arrow to
reduce the output of the AF1 or AG1 by 15 dB when your instru-
ment is putting out too hot a signal. See the "Setting Up and Using
the AirLine System" section on page 12 in this manual.
4: Power switch - Move this switch in the direction of the arrow to
6
turn power to the AF1 or AG1 on; move it away from the arrow to
turn power off.
5: Antenna - This permanently attached flexible antenna should be
7
fully extended during normal operations. See the "Setting Up and
Using the AirLine System" section on page 2 in this manual for more
information about antenna positioning.
6: Battery cover - Pull back gently on this cover at the ribbing and
pry upwards to remove. See the "Setting Up and Using the AirLine
System" section on page 12 in this manual.
7: Battery compartment - Insert a standard AAA alkaline battery
here, being sure to observe the plus and minus polarity mark-
ings shown. We recommend the Duracell type battery. Although
rechargeable Ni-Cad batteries can be used, they do not supply
adequate current for more than four hours. WARNING: Do not
insert the battery backwards; doing so can cause severe damage to
the AF1 / AG1 and will void your warranty.
11
Publicité
Table des Matières
