Fracarro Compact Line QPSK Instructions D'emploi page 20

5.3 CHANNEL SETUP MENU - PROGRAMMING THE RECEIVERS
From the first menu press the
receiver configuration.
Select the receiver to program and then gain access to the input, output and aux menu.
See chapter 5.3.1, 5.3.2 and 5.3.3 for details on the parameters to be set.
CHANNEL SETTING
FUNCTION "MODULE SEARCH"
TO BE USED WHEN CHECKING
IF THE MODULES
ARE WORKING PROPERLY
(see page 24)
COPIES THE PARAMETRES
OF ONE CHANNEL TO
ANOTHER (see page 24)
HARDWARE RESET
OF ONE OR ALL THE
CHANNELS (see page 24)
This section is for inputting the parameters for the selected channels:
• remote power for LNB
• IF frequency of the program to receive
• symbol rate
• selected program
key when the cursor is on CHANNEL SETUP to get access to the
CHANNEL 1
CHANNEL 6
SCAN MODULES
MODULE SEARCH
COPY CHANNELS COPY FROM ...
ALL CHANNELS
RESET
5.3.1 SETTING INPUT PARAMETERS
INPUT DATA SETTING
INPUT
(SEE CHAPTER 5.3.1)
OUTPUT DATA SETTING
OUTPUT
MEASURES
(SEE CHAPTER 5.3.3)
CHANNELS
FOUND
PASTE ON ...
MODULE 1
WAIT...
20
(SEE CHAPTER 5.3.2)
INPUT SIGNAL
MEASUREMENTS
MODULE 6