Machine Specifications; Transport And Installation; Transport; Installation - Jet SS-5N Mode D'emploi

Do not operate the machine under
the influence of drugs, alcohol or any
medication. Be aware that
medication can change your
behaviour.
Keep children and visitors a safe
distance from the work area.
Keep guards in place and in working
order.
Specifications regarding the
maximum or minimum size of the
work piece must be observed.
Support long work pieces with
helping roller stands.
Do not stand on the machine.

4. Machine specifications

4.1 Technical data
SS-5N
Shear capacity (St 37):
Max sheet capacity
Max. flat stock 70 x 5 mm
Max. round stock
Blade length
Overall (LxWxH) 390x175x430 mm
Net Weight
SS-6N
Shear capacity (St 37):
Max sheet capacity
Max. flat stock 70 x 6 mm
Max. round stock Ø11 mm Max
Blade length
Overall (LxWxH) 400x175x430 mm
Net Weight
SS-8N
Shear capacity (St 37):
Max sheet capacity
Max. flat stock 70 x 7 mm
Max. round stock Ø13 mm Max
Blade length
Overall (LxWxH) 430x175x430 mm
Net Weight
SS-12N
Shear capacity (St 37):
Max sheet capacity
Max. flat stock 70 x 6 mm
Max. round stock Ø13 mm Max
Blade length
Overall (LxWxH) 560x175x430 mm
Net Weight
*Material strength and ductility may
vary a lot. The given values are for
approximate reference only.

5. Transport and installation

5.1 Transport

If you notice transport damage while
unpacking, notify your supplier
immediately. Do not operate the
machine!
Dispose of the packing in an
environmentally friendly manner.
Clean all rust protected surfaces with
petroleum, diesel oil or a mild
solvent.
Coat all machined surfaces with a
light coat of oil to inhibit rust.

5.2 Installation

The machine is designed to operate
in closed rooms and must sufficiently
be bolted to a cabinet stand or a
solid work bench (C, Fig 1).
4 mm
Ø10 mm
120 mm
10 kg
5 mm
160 mm
13 kg
To avoid tipping, the machine
5 mm
must be bolted down!
200 mm

5.3 Assembly

Mount the operating handle (A).
25 kg
Mount the hold down (B).

6. Machine operation

5 mm
Specifications regarding the
maximum or minimum size and
thickness of the work piece must be
observed.
300 mm
Failure to comply m ay cause severe
machine damage.
29 kg
The hold down (B) must be lowered
to the work piece to support leverage
forces during the cut.
Fig 1
4
Support long work pieces with
helping roller stands.
Sheet metal stock has sharp edges.
WEAR GLOVES when handling
sharp edged work pieces.
WEAR SAFETY GLASSES.
KEEP HANDS AND FINGERS clear
of the shearing area.

7. Maintenance

Lubrication:
The machine must be lubricated
every day of service with a few drops
of oil.
Lubricate all slide and pivot points of
the machine.
Coat all machined surfaces with a
light coat of oil to inhibit rust.

8. Environmental protection

Protect the environment.
Your appliance contains valuable
materials which can be recovered or
recycled. Please leave it at a
specialized institution