Description Of The Unit; Operation; Handling - Daikin Zanotti GS Notice De Mode D'emploi Et D'entretien

3 Description of the unit

The GS series includes air-cooled or water-cooled (optional) condensing units built in split version. They
consist of:

4 Operation

GS single blocks are compression units where cold is produced by vaporizing a liquid refrigerant (HFC
type) at low pressure in a heat exchanger (evaporator). The resulting vapour is brought again into the liquid
state by mechanical compression at a higher pressure, followed by cooling in another heat exchanger
(condenser).
The compressor is hermetic, with reciprocating motion, supplied with single-phase or three-phase power.
Defrost takes place automatically in pre-set cycles, by means of heaters; manual defrost is also possible.
5

Handling

The unit can be handled by lifting and transport means.
UNSCREW THE FIXING SCREWS TO REMOVE CRATING FROM THE UNIT. (fig. A).
W AR NI NG
M ake sure that no one is in transit in the operating area of the lifting/ transport m eans
to prevent any possible accidents to people.
I f the unit is in a w ooden case or crate, sling the packing properly before handling it.
Lifting speed shall be such as not to m ake the packed unit oscillate dangerously and
possibly fall.
20
1. a condensing unit placed outside the cold room;
2. an evaporator installed inside the cold room;
3. an electric control panel placed on the condensing unit, complete with
wall-mounted remote control panel;
4. two tubes (pre-charged with refrigerant) to be connected to the
corresponding fittings placed on the evaporating and condensing units.
Fig. A