Electrical Requirements - Haier HCR2250AES Instructions D'installation

Power Supply
3¾"
(9.5 cm)
2" (5.1 cm)

ELECTRICAL REQUIREMENTS

IMPORTANT: Use a 3-wire, UL listed, 40-amp power supply cord (pigtail); or if local
codes do not permit grounding through the neutral, use a 4-wire power supply cord
rated at 250 volts, 40 amps and intended for use with ranges.
If codes permit and a separate ground wire is used, it is recommended that a
qualified electrical installer determine that the ground path is adequate and wire
gauge is in accordance with local codes.
To properly install your range, you must determine the type of electrical connection
you will be using and follow the instructions provided for it here.
•
Range must be connected to the proper electrical voltage and frequency as
specified on the model/serial number rating plate. All models are dual rated, and
designed to be connected to either 120/208 or 120/240V AC, 60Hz, 3-wire or
4-wire, single-phase power supply.
Voltage and
Frequency
240V, 60 Hz
208V, 60 Hz
•
When a 4-wire, single phase 120/240 volt, 60 Hz., AC only electrical supply is
available, a 40-amp maximum circuit protection is required (or, if specified on
the model/serial rating plate, when a 4-wire, single phase 120/208 volt 60 Hz.,
AC only electrical supply is available, a 35-amp maximum circuit protection is
required).
•
For direct wire installations, install a suitable conduit box (not furnished). An
appropriately sized, UL conduit connector must be used to correctly attach the
conduit to the junction box.
IMPORTANT: Local Codes may vary; installation electrical connections and
grounding must comply with all applicable local codes.
24"
(61.0 cm)
13"
(33.0 cm)
15"
(38.1 cm)
a
20"
(50.8 cm)
Amps Minimum Circuit Required
40 Amp Circuit
37.3A
32.4A 35 Amp Circuit
2"
(5.1 cm)
a
Area to
Locate
Electrical
Outlet
5