Step 4 - Install Range - Haier HCR2250AES Instructions D'installation

12. Position the lower part of the strain relief under the conduit and tighten the
strain relief screws.
NOTE: Before tightening, make sure the strain relief is positioned over the
conduit and NOT the wires.
13. Replace the back panel screws, and then fully tighten the screws.
14. Tuck excess conduit under the range.

STEP 4 - INSTALL RANGE

IMPORTANT: If the range is moved to adjust the leveling legs, make sure when you
move the range back into its final location that the anti-tip bracket is engaged by
repeating steps 1 through 9.
1. Slide range into final location, making sure rear leveling leg slides into anti-tip
bracket. Leave a 1" (2.5 cm) gap between the back of the range and the back wall.
2. Place the outside of your foot against the bottom front to keep the range from
moving, and then grasp the back of the range, as shown.
3. Slowly attempt to tilt the range forward.
If you encounter immediate resistance, the range foot is engaged in the anti-tip
bracket. Go to Step 8.
22
a
a
Strain Relief
Screws
b
b
Lower Part of
Strain Relief